Fabryczny katalog części zamiennych 3m Hf05 Ms

Subskrybuj nasze sieci społecznościowe, aby być na bieżąco z najnowszymi aktualizacjami!

Komentarz

Yes thank you did this last night and it worked brilliant no costly outlay for repairman!

I had the same problem. I replaced the heater, and now I works

You lovely man. My wash was just stuck on 1 minute, constantly spinning and getting ridiculously foamy. Door wouldn't unlock even when I switched it off. One wet and soapy floor later, problem solved, thank you

I fixed my washing machine after that I watched this video!!!! Thanks so much!

I've had exactly the same problem and in my case the solution was simple. I had either underloaded or overloaded the washer. Looking at what you'd got in there, it looks like you may be close to overloading.

Thanks for this. Because of this video I learned there’s a manual drainage hose.

I had the same problem. So I watched this video, cleared the filter and drain pipe but it didn't solve the problem.

Just encountered the same problem and now it works

Thanks for puting this up on youtube as it gave me some ideas to the reason why my Bosch machine was doing the same thing and as one of the guys said in here is that the heating element stops working and the machine waits for the temperature to go to the desire temp setting but of course never does and continues washing until

if the pump is clear ,always check the drain hose. I had this fault and it was due to  large sequins [ 20mm diameter] from my daughter's dress stuck where the outlet met the sink drain.

I'd like to see if the machine failed next time on the original cycle, as my Bosch varioperfect gets stuck at 1 min remaining only on the delicate/silk cycle but appears to work normally on 30/40/60 degree cycles?

I think I've solved it. I had the same problem, stuck @1min forever. Eventually it came up with E6. It turned out to be a disconnected (brown) wire to the pump. I managed to pull the plug out from it's connection to the pump and open it up. I reconnected the wire and hey presto problem solved. I too had cannibalised 2 machines into one, swapping control panels. Initially I thought they were incompatible even though they were both Maxx 1000rpm machines but 2010 and 2008 models. The CP of the 2008 works perfectly well in the 2010. Don't be put off by different colours. I'm sure the short was the reason for blowing the CP - black smoke marks in the SAME spot.

Thanks for your information bro..

On B/S/H/ machines, sticking on

I got the same problem

I have had a blown motherboard ...now replaced and all OK. Realised water not heating so I replaced the element and thermostat but still not heating the water on a 40 degree wash . Any advice

Since the pump was clear I would keep an eye on the sump hose or the heater, the heaters are known to make Bosch machines get stuck at 1min to go as it's not heating but won't drain because it's not reached the temp that is selected

it was the same problem , 1 min error

I have a washing machine of this type. It stopped mid cycle and turned itself off. I was able to open the door but it has some water in it.. I had to put a pair of shoes in because my father had trod in his own poo while in hospital so had to wash them properly to avoid contamination. Do I just remove the door at the bottom and drain it? If so, will it work again once I have finished? Thanks.

It was the same problem, one min error isuse was heater. Maybe in you case it is thermostat.

.

Zostaw komentarz

#0